MIMAKI JV33-260 - Setting Stamp

3-32
Setting Stamp
Set whether information such as the drawing conditions or the date printed is output after the completion of
printing or not.
1
Press the key in the local mode.
2
Select [MACHINE SETUP] by pressing the keys.
3
Press the key.
4
Select [STAMP SETUP] by pressing the keys.
5
Press the key.
6
Select ON/OFF by pressing the keys.
7
Press the key.
8
Press the key several times to end.
Examples of Output
FUNCT I ON
SETUP <ENT>
FUNCT I ON
MACH I NE S E TUP < ENT >
MACH I NE S E TUP
DEODOR I Z E F AN < e n t >
MACH I NE S E TUP
STAMP SETUP <en t >
STAMP SETUP
STAMP :
OFF