MIMAKI JV33-260 - Replacing the Wiper

5-7
Maintaining Capping station
1
2
3
4
5
Routine Maintenance
Replacing the wiper
The wiper is consumable.When the display indicates that it is necessary to
replace the wiper, immediately replace the wiper with a new one.
Also, wipe ink sticking to the lower surface of the slider off.
1
Press the key in the local mode.
2
Select [WIPER EXCHANGE] by pressing the
keys.
3
Press the key.
• The carriage moves onto the platen.
4
Open the front cover then remove the wiper.
• Pull out the wiper by holding the projections at both ends.
5
Insert a new wiper.
• Install the wiper by holding the projections at both ends.
6
Close the front cover then press the key.
• After performing the initial operation, the machine returns to LOCAL
mode.
• The wiper to be newly installed is available as an option. Order it from your dealer or a sales office of
MIMAKI.
• Do not select [WIPER EXCHANGE] at any time other than when the wiper is to be replaced.Once it is
selected, the number of wiper operations that is counted in the machine will be reset.
<LOCAL . 1> [ #01 ]
!Repl ace a WIPER
ST . MA I NTENANCE
CARR I AGE OUT < e n t >
ST . MA I NTENANCE
WI PER EXCHANGE < e n t >
ST . MA I NTENANCE
COMPL ET ED : e n t
Projection
Projection
( COVER OPEN )
PRESS <ENT> KEY
*Be i ng I n i t i a l i zed*
PLEASE WA I T