MIMAKI JV33-260 - Preventing nozzle clogging while power-off

5-24
Preventing nozzle clogging while power-off
Even while the power switch is off, the machine starts periodically and executes various functions to prevent
nozzle clogging. [SLEEP SETUP] includes the following functions.
Setting refreshing interval in Sleep mode
Set the interval at which the nozzles will eject a little volume of ink to prevent nozzle clogging.
1
Select [SLEEP SETUP] of the maintenance menu.
(1) Press the key in the local mode.
(2) Select [MAINTENANCE] by pressing the keys then press the key.
(3) Select [SLEEP SETUP] by pressing the keys.
2
Press the key.
3
Press the key.
4
Set the refreshing interval by pressing the
keys.
• Set value : OFF, 1 - 168 hours
5
Press the key.
6
Press the key several times to end.
Function name Descriptions
REFRESH Set the interval at which refreshing operation is to be performed periodically.
PUMP TUBE WASH Set the interval at which cleaning of the pump tubes is to be performed
periodically.
CLEANING Set the cleaning type and the interval at which cleaning operation is to be
performed periodically.
• During the right message is displayed, the operation set in the sleep
setting is not carried out. Perform the operations of P.5-38 if
required.
• When the power switch on the front of the machine is turned off,
check the waste ink tank.
<LOCAL .1> [#01 ]
!WASTE TANK
SLEEP SETUP
REFRESH < en t >
SLEEP SETUP
REFRESH i n t e r v a l =
1 h
SLEEP SETUP
REFRESH i n t e r v a l = 1
0 h
SLEEP SETUP
REFRESH < en t >