6-9
Warning / Error Messages
1
2
3
4
5
6
Troubleshooting
Message Cause Solution
The cover of the heavy-duty feeding
device opens.
Close the cover of the heavy-duty feeding
device.
If the error message is displayed even if
the cover is closed, contact our service
and sales office.
The control limit sensor of the
heavy-duty feeding device is
detected.
Move down the position of the tension bar
at the drawn side. If the error message is
displayed even if you move it down,
contact our service and sales office.
An abnormality occurs in the status
of drawn of the heavy-duty feeding
device.
Conform whether the medium is set on the
heavy-duty feeding device properly.
Confirm whether the medium goes around
in circles or not.
To Next Page
Loading...
