MIMAKI JV33-260 - CHAPTER 5 Routine Maintenance

This section describes the items required to use this machine
more comfortably, which are the procedures of ink replacing,
cleaning or the like.
Maintaining ............................................ 5-2
Precautions in cleaning .........................5-2
Notes on cleaning solution ....................5-2
Cleaning exterior surfaces .....................5-3
Cleaning the platen ...............................5-3
Cleaning of after heater cover and pre
heater cover ..........................................5-3
Cleaning the media sensor ....................5-4
Cleaning the media press ......................5-4
Maintaining Capping station ...............5-5
Cleaning the wiper and ink caps ...........5-5
Replacing the wiper ...............................5-7
Prior to Pump tube washing ..................5-8
Washing of Head nozzle .....................5-10
Cleaning the ink discharge passage
(PUMP TUBE WASH) .........................5-12
When not using for a long term
(CUSTODY WASH) .............................5-14
Cleaning heads and surroundings
parts ..................................................... 5-16
When Nozzle clogged after
cleaning ...............................................5-18
Filling up ink ........................................5-18
DISCHARGE & WASH ........................5-19
Initial ink fill up .....................................5-21
If dots misalign ...................................5-23
Preventing nozzle clogging while
power-off .............................................5-24
Setting refreshing interval in Sleep
mode ................................................... 5-24
Setting tube washing interval in Sleep
mode ................................................... 5-25
Setting cleaning interval in Sleep
mode ................................................... 5-26
Setting Routine operations ................5-27
Setting Routine wiping operations in
Standby mode ..................................... 5-27
Setting Refreshing interval in Standby
mode ................................................... 5-29
Setting Pump tube washing interval in
Standby mode ..................................... 5-30
Setting Cleaning interval in Standby
mode ................................................... 5-31
Other maintenance functions ............5-32
Changing the warning time of wiper
replacement ........................................ 5-32
Setting the media remaining display ...5-33
White Ink Maintenance Function ......... 5-35
If Waste ink tank confirming message is
displayed ............................................. 5-37
Changing the ink ................................. 5-41
Replacing the cutter blade .................5-42
CHAPTER 5
Routine Maintenance