When Nozzle clogged after cleaning
5-22
5
Set an ink cartridge to the ink station.
• When the ink cartridge is set, filling is automatically started.
• Upon the ink station, the inserting location is allocated for each ink
color. Set the ink cartridge according to the cartridge label under the
ink station.
6
It returns to the local mode when the ink filling is
completed.
If ink is not filled in step 5
If [INK NEAR END], [INK END] or other ink errors occur, it does not start ink filling.
If ink filling is not started in “Initial ink fill up” step 5
(1) Press the key to go back to the display of step 2.
(2) Press the key to check the state of the ink cartridge.
(3) Solve an ink error or others ( P.6-5), operate from step 2 again.
• If blurring or missing is found in printing after initial fill of ink, "Head Cleaning"( P.2-36) or "Filling up
ink"( P.5-18) .
Set :ES3-4color Ink
--C- Y-KK
The front side
4 colors model:
6 colors model:
6 colors + White model (SS21):
7 colors model (Eco-PA1):
8 colors model (ES3):
for the firmware V.4.60 and later
<LOCAL . 1> [ #01 ]
width:****mm
To Next Page
Loading...
