MIMAKI JV33-260 - Page 168

5-34
Print the media remaining amount
You can print the current media remaining amount.
1
In the local mode,
press the keys.
• It enters into the origin setting mode.
2
Set a light point of the LED pointer to the changing position by pressing the
keys.
• Select the carriage and media, moving the point with the
keys.
• When not changing the origin, proceed to the Step 3 without
pressing , , and key.
• When pressing key here, the origin will be changed and it
will return to the local mode.
3
Press the key.
• When pressing , , and key, the screen will
return to the Step 2 screen.
• When pressing key, it will return to the local mode.
4
Press the key.
• Start printing of the media remaining amount.
• When the printing completes, it will return to the local mode.
• Set [MEDIA RESIDUAL] to “ON”. ( P.5-33)
• When changing the media, it is recommended to print the remaining amount to the currently used media.
If you print the media remaining amount in advance, for using the changed media, you can enter the
correct value in the screen for entering media remaining amount after detecting the media ( P.2-24).
• When printing after changing the origin, the origin set here will be valid when printing data subsequently.
OR I G I N SE TUP
0.0 ----
OR I G I N SE TUP
0.0 0.0
Origin
(Length)
Origin
(Width)
MED I A RES I DUA L DRAW
<ENT>