MIMAKI JV33-260 - Page 191

Warning / Error Messages
6-13
1
2
3
4
5
6
Troubleshooting
Message Cause Solution
The heavy-duty feeding device is not
connected.
Once turn OFF the power supply and
after a while, turn it ON again.
If the error message is displayed again,
contact our service and sales office.
The heavy-duty feeding device is
connected to a wrong position.
An abnormality occurs in the heavy-
duty feeding device.
The ambient temperature is out of the
usable temperature range (too low).
Adjust the ambient temperature of the
installation place. ( P.3-34)
The ambient temperature is out of the
usable temperature range (too high).
There is a slot where no cartridge has
been inserted.
Set a cartridge.
An error occurred on the head unit
memory.
Turn off the main power to the machine
and turn it on after a while.
If the same error message appears
again, contact your local distributor to
call for service.
The head is not connected.
An error occurred on the head slider
board.
The head is not MIMAKI genuine.
A SD-RAM of the size required for the
machine has not been equipped.
Turn off the main power to the machine
and turn it on after a while.
If the same error message appears
again, contact your local distributor to
call for service.
(When a usable SD-RAM is available,
the machine can be started as is.
However, a printing speed may be slow
depending on resolution. )
An abnormal voltage of head was
detected.
Turn off the main power to the machine
and turn it on after a while.
If the same error message appears
again, contact your local distributor to
call for service.
An error is detected on the waveform
printed on the lower line of the display.
Model ID of main PCB is different.
(XX is ID code.)
An abnormal temperature of the media
heater was detected.
An abnormal temperature of the head
heater was detected.
An error was detected during scanning
operation.
Turn off the main power to the machine
and turn it on after a while.
If the same error message appears
again, contact your local distributor to
call for service.
A system error occurred.
***** ERROR 67 *****
FEEDER UN I T 0 1
***** ERROR 67 *****
FEEDER UN I T 0 2
***** ERROR 67 *****
FEEDER UN I T 0 4
**** ERROR 120 ****
ENV I RONMENT TEMP ( LO )
**** ERROR 121 ****
ENV I RONMENT TEMP ( H I )
**** ERROR 144 ****
CARTR I DGE SET !
**** ERROR 200 ****
HEAD MEMORY (----)
**** ERROR 202 ****
DVE I CE CONSTRUCT I ON
**** ERROR 203 ****
SDRAM S I ZE
**** ERROR 205 ****
42V HEAD Vo l t age
**** ERROR 207 ****
XXXXXXXXXX
**** ERROR 208 ****
CHECK MA I N PCB I D XX
**** ERROR 211 ****
HeaterTEMP(--/--/--)
**** ERROR 211 ****
HeadWARM.TEMP.(----)
**** ERROR 250 ****
YCOORDINATES
**** ERROR 251 ****
SYSTEM ERROR