The procedures from the ink and media preparation to drawing
and the setting procedures are described.
User type ........................................ 2-2
Set items registrable to User type ..... 2-2
Using the registered user type .......... 2-2
Workflow ......................................... 2-3
Turning the power ON/OFF ........... 2-4
Turning the power ON ....................... 2-4
Turning the power OFF ..................... 2-5
Setting medias ............................... 2-6
Adjusting the head height .................. 2-6
Note for media setting ....................... 2-8
Setting a heavy-duty roll media ......... 2-9
Setting a narrow roll media ............. 2-20
Narrow take-up device .................... 2-25
Setting leaf media ........................... 2-26
Changing the printing origin ............ 2-28
Preparing Heaters ........................ 2-30
Changing temperature settings of
Heater ............................................. 2-30
Confirming the Heater temperature . 2-31
Test printing ................................. 2-32
Perform test printing with the normal
test pattern ...................................... 2-33
Perform test printing with the test
pattern for checking white ink ......... 2-34
Check warning of white nozzle status
(Only when using SS21 white ink) .. 2-35
Head Cleaning .............................. 2-36
About head cleaning ....................... 2-36
Perform head cleaning depending
on the test printing result ................ 2-37
Perform spot color maintenance ..... 2-37
Drawing data ................................. 2-40
Starting the print ............................. 2-40
Stopping the print temporarily ......... 2-41
Erasing the received data
(Data clear) ..................................... 2-41
Cutting a media ............................... 2-42
CHAPTER 2
Basic Operations
To Next Page
Loading...
