2-11
Setting medias
1
2
Basic Operations
5
6
Set a heavy-duty roll media
Set a heavy-duty roll media to the heavy-duty feeding device on the back of this machine.
When setting a heavy-duty roll media, set “ON” on [Feeding/TakeUP] of MACHINE SETUP.
1
Set “ON” on [UNIT SELECT] of [Feeding/TakeUP] in MACHINE SETUP. ( P.3-29)
2
Remove the roll shaft on the heavy-duty feeding device at the back of this machine.
(1) Open the covers on the right and the left of the heavy-duty feeding device.
(2) Remove the roll shaft.
• To prevent dust, set the paper core or media to the roll shaft on the table or sheet.
Dust on the paper core or on the media may cause defective print.
3
Remove the heavy-duty roll holders.
• The heavy-duty roll holders are on both sides of the shaft.
Remove them with the following procedures.
(1) Loosen the screws with the supplied hexagonal wrench.
(2) Remove the heavy-duty roll holders.
• Since the roll media is heavy, set it by two or more people. Take care not to drop it on the foot, and not
to hurt your back.
• Handle the clamp lever carefully.
It is dangerous to push the lever up when the tension-bar is lifted. Be sure to fix the tension-bar with the
lock and push up / down the lever.
• Grip the handles on both ends of the roll shaft.
If gripping the other parts, your hand may get stuck in.
Be careful not to hurt your back.
Hexagonal wrench
Heavy-duty
roll holder
To Next Page
Loading...
