2-13
Setting medias
1
2
Basic Operations
5
6
6
Open the front cover and raise the clamp lever at the
front of this machine.
7
Slide the media from the back to the front.
• Insert the roll media between the platen and the pinch roller,
and slide it to the front.
• Pull the media out to the front of this machine with enough
length.
8
Push the clamp lever down at the back of this
machine.
• Lock the media temporarily.
9
Raise the clamp lever at the front of this machine.
• Temporary lock of the media is released.
10
Pull out the media.
• Holding both ends of the media by two people, pull out the media end about 50cm longer than the floor.
• To set the media straight, pull out the media long.
To Next Page
Loading...
