MIMAKI JV33-260 - Page 45

2-15
Setting medias
1
2
Basic Operations
5
6
14
Adjust the position of the tension-bar with the switches on the left of the heavy-duty
feeding device.
(1) Set the  switches to the take-up direction of the media.
(2) Turn the left switch to [MANUAL].
• The tension-bar is lifted, reeling the media. When the media is fed and the tension-bar is not
lifted, turn the
 switch to the other side.
(3) When the tension-bar arm becomes parallel to the floor, turn the left switch to AUTO to stop the
tension-bar.
(4) Turn the  switch to the feeding direction of the media.
15
Hold the media lightly with the media press.
• Set the media not to get out of the right of the pinch roller on the right end.
• When using a thick media, remove the media press from the media before printing.
• Do not set media at the position which the media press touches the side plate on the right.
As media may tilt and be lifted, it could break the head.
• If a media is misaligned to the right more than fixed
position, a warning is displayed. Set the media again.
Adjust the arm to become parallel to the floor
***** ERROR 50 *****
MED I A SE T POS I T I ON
Media press position : 8 to 18 mm from the side plate on the right.
(For the variation of the inside diameter of media roll, it ranges as above.)
• Do not locate the suction hole on the platen
between the media and the media press. (It
may stain the media.)
Suction
hole