2-22
11
Make the roll media even then lower the clamp lever.
• Pulling several positions of the media lightly, Lower the clamp
lever after confirming that the amount of the roll media pulled
out is almost even.
12
Hold the media with the media press gently.
• Set the media so that no media sticks out from the right end
pinch roller to the right side.
• When using a thick media, remove the media press from the
media before printing.
• Do not set media at the position which the media press touches the side plate on the right.
As media may tilt and be lifted, it could break the head.
• If a media is misaligned to the right more than fixed
position, a warning is displayed. Set the media again.
***** ERROR 50 *****
MED I A SE T POS I T I ON
Media press position : 8 to 18 mm from the side plate on the right.
(For the variation of the inside diameter of media roll, it ranges as above.)
• Do not locate the suction hole on the
platen between the media and the media
press. (It may stain the media.)
To Next Page
Loading...
