Chapter 3 Adjustment > Mechanical Adjustment>Wiper Height Adjustment
117
8. Loosen the retaining screws.
9. Loosen the two height adjustment screw lock nuts.
Lock nut
Height adjustment screw
10. Move the wiper backward or forward by hand and rotate the adjuster screw to adjust the overlap
between the wiper and the nozzle surface to the specified value.
• Specified value: 2.5 mm
• Clockwise: Raises the wiper
• Counterclockwise: Lowers the wiper
[Front view]
Wiper
Head (Nozzle surface)
11. After adjusting, tighten the retaining screws.
3
To Next Page
Loading...
