Chapter 2 Replacement of Maintenance Parts > Sensor Related>DAS
54
>
R
e
v
2.2.6 DAS
l Procedure
1. Turn off the main power supply and unplug the power cable.
2. Remove the following covers.(1.5)
(1) Front cover front
(2) Carriage cover
3. Remove the head lock screw on the left.
4. Disconnect all connectors connected.
5. Remove the DAS.
6. Follow the procedure in the reverse order for assembly.
l Connector list
No. Pin Purposes AC/DC Remarks
CN1 4 For Slider M PCB connection DC
*1. For details of the ports to connect to, check the block diagram.
To Next Page
Loading...
