MIMAKI TS100-1600 - Chapter 5 Troubleshooting

Chapter 3 Adjustment > Mechanical Adjustment>Encoder Sensor Height Adjustment
119
>
R
e
v
3.1.6 Encoder Sensor Height Adjustment
l Overview
Check the encoder sensor height.
l Procedure
1. Turn off the main power supply and unplug the power cable.
2. Remove the following covers.(1.5)
(1) Front cover front
(2) Front cover upper
(3) Carriage cover
3. Loosen the encoder sensor BKT retaining screw.
Encoder sensor BKT
4. Adjust the encoder sensor BKT up or down so that the encoder sensor is in no contact with the linear
encoder scale.
Linear encoder scale
Encoder sensor
5. After adjusting, tighten the encoder sensor BKT retaining screw.
3