MIMAKI TS100-1600 - 3.2.7 Edge Adjust

Chapter 3 Adjustment > Adjust Menu>Edge Adjust
140
>
R
e
v
3.2.7 Edge Adjust
l Overview
Adjust so that the left- and right-hand margin widths on the media match the specified value (15 mm).
• Errors of approximately ±0.5 mm may occur due to variations with the pinch roller.
l Procedure
1. Position the media.
2. Select [#Adjust] > [Edge Adjust], then press the [ENTER] key.
3. Press the [ENTER] key to print the built-in pattern.
• Press the key to go to the correction value input screen.
4. Check the built-in pattern.
• Measure the distance from the media edge to the built-in pattern.
Measurement Measurement
5. Enter the measured value from the media edge to the built-in pattern, then press the [ENTER] key.
• Enter the measured value, and not the difference from the specified value (15 mm).