MIMAKI TS100-1600 - LICENSE Library

Chapter 3 Adjustment > Adjust Menu>Wiper Adjustment
137
6. Clean and then confirm that the wiper is as shown below.
• Check while the carriage is on the return travel.
No goodOK
Head base
Head
Head base
Head
Head base
Head
Touching the
protruding part of the
head base
Touching the head Not touching the
head base
X direction position adjustment
• Adjust each Head.
l Procedure
1. Select [#ADJUST] > [Wiper Adjustment] > [WIPER POS.(H1)/(H2)], then press the [ENTER] key.
2. Open the front cover.
3. Remove the following covers.(1.5)
(1) Front cover lower right
4. Adjust the position as shown below and press the [ENTER] key.
• Align the wiper with the center of the Head.
• : Moves the wiper in the X direction
• [SELECT]: Confirms operation
Rear
Front
Center
Head
Wiper
[Side view]
3