MIMAKI TS100-1600 - 3.2.8 Pointer Offset

Chapter 3 Adjustment > Adjust Menu>Pointer Offset
141
>
R
e
v
3.2.8 Pointer Offset
l Overview
Adjust the origin of the LED pointer.
l Procedure
1. Select [#Adjust] > [Pointer Offset], then press the [ENTER] key.
2. Press the [ENTER] key to print the built-in pattern.
• Printing a built-in pattern resets the stored values.
3. Check the built-in pattern.
• Check to confirm that the LED pointer overlaps the intersection of the straight lines.
LED pointer
4. Perform the following if adjustment is required.
(1) Align the LED pointer with the intersection of the straight lines, then press the [ENTER] key.
: Move the LED pointer
3