MIMAKI TS100-1600 - 3.2.4 Wiper Adjustment; Y direction position adjustment

Chapter 3 Adjustment > Adjust Menu>Wiper Adjustment
136
>
R
e
v
3.2.4 Wiper Adjustment
l Overview
Adjust the wiper position in the X and Y directions.
To adjust the wiper height, perform the following:
Reference: "3.1.5 Wiper Height Adjustment"(P. 116)
• If the position is offset, the wiper will be unable to wipe off ink from the nozzle surfaces. This
may cause problems such as nozzle clogging and improper cleaning.
Y direction position adjustment
l Procedure
1. Select [#ADJUST] > [Wiper Adjustment] > [WIPER POS.(Y)] and press the [ENTER] key.
2. Open the front cover.
3. Remove the following covers.(1.5)
(1) Front cover lower right
4. Adjust the position as shown below and press the [ENTER] key.
• Align the wiper with the groove on the left-hand side of the Head 1 on the underside of the
carriage.
• : Moves the carriage in the Y direction
Head
Wiper
Head base
• The wiper does not move.
5. Adjust the position as shown below and press the [ENTER] key.
• Adjust the gap between the side of the Head 1 and the wiper to 1 mm.
• : Moves the carriage in the Y direction
• [SEL]: Confirms operation
Move the carriage to adjust
[Front view]
Wiper