MIMAKI TS100-1600 - 3.2.6 Feed Comp 2

Chapter 3 Adjustment > Adjust Menu>Feed Comp 2
139
>
R
e
v
3.2.6 Feed Comp 2
l Overview
Adjust the media feed amount.
l Procedure
1. Position the media.
2. Select [#Adjust] > [Feed Comp 2], then press the [ENTER] key.
3. Press the [ENTER] key to print the built-in pattern.
• Press the key to go to the correction value input screen.
4. Check the built-in pattern.
OK
No good
No good
Correction value is too
large.
Correction value is too
small.
5. Enter the correction value, then press the [ENTER] key.
• : Correction value input (-9,999 to 9,999)
• The correction values for each media entered in [Setup] > [Feed Comp.] will be added to
the correction value entered here.
6. Execute [Setup] > [Feed Comp.].
3