MIMAKI TS100-1600 - 2.4.3 Selective Route Pump

Chapter 2 Replacement of Maintenance Parts > Ink Supply Related>Selective Route Pump
82
>
R
e
v
2.4.3 Selective Route Pump
1
l Procedure
1. Turn off the main power supply and unplug the power cable.
2. Remove the following covers.(1.5)
(1) Right side cover lower
3. Detach the fittings on the cap side.
• Be careful to avoid contaminating the surrounding area with ink.
• Be careful to avoid bending the ink tubes.
Cap side
4. Detach the fitting on the waste ink tank side.
• Be careful to avoid contaminating the surrounding area with ink.
• Be careful to avoid bending the ink tubes.
Waste ink tank side
5. Disconnect all connectors connected.