Chapter 3 Adjustment > Mechanical Adjustment>Wiper Height Adjustment
116
>
R
e
v
3.1.5 Wiper Height Adjustment
l Overview
Check to confirm that the wiper height is within the specified value. If it is not within the specified value, move
the wiper backward or forward by hand and rotate the adjuster screw to adjust the overlap between the wiper
and the nozzle surface to the specified value.
If the position is offset, the wiper will be unable to wipe off ink from the nozzle surfaces. There is a risk of
nozzle clogging or improper cleaning.
To adjust the wiper position in the X and Y directions, perform "3.2.4 Wiper Adjustment"(P. 136).
l Procedure
1. Select [Maintenance] > [Station Maint.] > [Carriage Out] > [Move To Platen Right End], then press the
[ENTER] key.
2. Turn off the main power supply and unplug the power cable.
3. Lower the clamp lever.
4. Remove the following covers.(1.5)
(1) Front cover front
(2) Front cover upper
(3) Front cover lower right
5. Loosen the two head lock screws.
• Note that the head may contact the platen.
6. Set the head height adjustment lever to the "LOW" position.
7. Tighten the two head lock screws.
To Next Page
Loading...
