Chapter 3 Adjustment
This chapter
This chapter describes the methods for mechanical and operational adjustment.
Mechanical Adjustment .................................104
Carriage Adjustment ................................ 106
Station Height Adjustment........................ 110
Cutter Unit Position Adjustment ............... 112
Jam Sensor Unit Height Adjustment ........ 114
Wiper Height Adjustment ......................... 116
Encoder Sensor Height Adjustment......... 119
Centering Adjustment of the Feeding and
Take-up Units........................................... 121
Adjusting the Path of the Feeding and Take-
up Units.................................................... 122
Adjust Menu ...................................................124
Drop.PosCorrect ........................................127
Head Adjustment .......................................130
Capping......................................................134
Wiper Adjustment.......................................136
Discharge and Washing.............................138
Feed Comp 2 .............................................139
Edge Adjust................................................140
Pointer Offset .............................................141
NCU ...........................................................142
Replace Head ............................................144
To Next Page
Loading...
