MIMAKI TS100-1600 - Ink Replacement Method

Chapter 2 Replacement of Maintenance Parts > PCB/Power Supply Related>Slider M PCB
37
>
R
e
v
2.1.3 Slider M PCB
1
4
3
2
l Procedure
1. Turn off the main power supply and unplug the power cable.
2. Remove the following covers.(1.5)
(1) Front cover front
(2) Front cover upper
(3) Top cover
(4) Right side cover upper
3. Unlock the clamps securing the ink tube.
4. Remove the ink tube from the clamps and wrap in a paper towel.
• Be careful to avoid contaminating the surrounding area with ink.
• Be careful to avoid bending the ink tubes.
5. Remove the bearing BKT.
[Side view]
6. Remove the following covers.(1.5)
(1) Carriage cover
(2) Slider PCB cover
• Hold the ink tube and slide the cover to the left.
Slider PCB cover
Carriage cover
7. Disconnect all connectors on the PCB.
2