Chapter 5 System Overview > Ink System>Ink Supply System Error
164
>
R
e
v
5.1.2 Ink Supply System Error
l Overview
Ink supply system errors are grouped as follows:
No. Item Overview
1 Error control • Checking errors is performed periodically. Certain operations may be
restricted, depending on error status.
2 Supply valve and LED
control
• If the Ink bottle has been removed, the operation stops, and the machine
will revert to local mode.
• No LED is fitted.
Error control
l Overview
No. Item Outline Status at time of error
Cleaning
/filling
Printing Head
cleaning
1 Ink End • The specified value was exceeded
after ink near-end was detected.
X X O
2 Ink near-end • Ink end is near. Detected at ink tank.
*Reverts to local mode each time after
printing a file.
X O O
3 Initial filling is not
performed
• Initial filling was not executed. X X O
4 Ink IC is not
registered
• The ink IC chip is not registered. X X O
5 Waste Ink Tank • The amount of waste ink exceeded the
specified value after near-full was
displayed.
X X X
6 Replace Wiper • The wiper usage count exceeded the
specified value.
O O O
*1. O: Can be performed, X: Cannot be performed
Supply valve and LED control
l Overview
Item Valve LED
Print Start - -
Normal Open -
Ink near-end -
Ink End Closed -
Print End Closed -
To Next Page
Loading...
