Chapter 3 Adjustment > Mechanical Adjustment>Cutter Unit Position Adjustment
112
>
R
e
v
3.1.3 Cutter Unit Position Adjustment
l Overview
Push down on the cutter blade at the left edge, center, and right edge of the platen to check. If the cutter
does not align with the cutter groove, adjust the position of the cutter blade so that it aligns with the platen
cutter groove.
l Procedure
1. Select [Maintenance] > [Station Maint.] > [Carriage Out] > [Move To Platen Right End], then press the
[ENTER] key.
2. Turn off the main power supply and unplug the power cable.
3. Lower the clamp lever.
4. Remove the following covers.(1.5)
(1) Front cover front
(2) Front cover upper
(3) Carriage cover
5. Temporarily tighten the cutter unit retaining screws.
• Slightly loosen: Unscrew one or two turns.
6. Adjust so that the cutter blade aligns with the platen cutter groove.
• Push down the cutter blade and adjust the position.
To Next Page
Loading...
