Chapter 2 Replacement of Maintenance Parts > Ink Supply Related>Damper
79
>
R
e
v
2.4.2 Damper
l Damper replacement procedure
Remove the covers.
Drain the ink from inside the damper and head.
Replace the damper.
Refill with ink.
• [Other required tools]
(1) Maintenance liquid (P. 16)
l Procedure
1. Turn off the main power supply.
2. Remove the following covers.(1.5)
(1) Front cover front
(2) Front cover upper
(3) Carriage cover
3. Release the C cover stay cable clamp.
4. Detach the C cover stay.
• Be careful to avoid damaging the cable.
5. Turn on the main power supply and press the [END/POWER] key.
6. Drain the ink.
• Reference: "3.2.10 Replace Head"(P. 144) Ink discharge from Head
7. Select [Maintenance] > [Station Maint.] > [Carriage Out] > [Move To Platen Right End] and press the
[ENTER] key.
8. Turn off the main power supply and unplug the power cable.
2
To Next Page
Loading...
