Chapter 2 Replacement of Maintenance Parts > Miscellaneous>Wiper unit
101
>
R
e
v
2.5.5 Wiper unit
l Procedure
1. Select [Maintenance] > [Station Maint.] > [Carriage Out] > [Move To Platen Right End], then press the
[ENTER] key.
2. Turn off the main power supply and unplug the power cable.
3. Remove the following covers.(1.5)
(1) Front cover front
(2) Front cover upper
(3) Front cover lower right
4. Remove the tube from the wiper tray and wrap in a paper towel.
• Be careful to avoid contaminating the surrounding area with ink.
5. Release the cable clamp on the underside of the Wiper unit.
6. Disconnect all connectors connected.
2
To Next Page
Loading...
