Chapter 2 Replacement of Maintenance Parts > PCB/Power Supply Related>ID contact PCB
43
>
R
e
v
2.1.7 ID contact PCB
l Procedure
1. Turn off the main power supply and unplug the power cable.
2. Remove the following covers.(1.5)
(1) Electrical box cover
3. Disconnect all connectors on the PCB.
4. Remove the ID contact PCB. (Claw ×2)
5. Follow the procedure in the reverse order for assembly.
l Connector list
No. Pin Intended use AC/DC Remarks
CN1 2 ID connection cable DC
*1. For details of the ports to connect to, check the block diagram.
2
To Next Page
Loading...
