Chapter 2 Replacement of Maintenance Parts > Ink Supply Related>Buffer Tank
91
>
R
e
v
2.4.8 Buffer Tank
l Procedure
1. Drain the ink.
• Reference: "3.2.5 Discharge and Washing"(P. 138)
2. Turn off the main power supply and unplug the power cable.
3. Remove the following covers.(1.5)
(1) Bottle top cover
(2) Bottle back cover upper
(3) Bottle cover R
(4) Bottle cover L
4. Remove the Bottle tank together with the tank BKT.
• Be careful to avoid bending the ink tubes.
5. Disconnect the tube connected to the Buffer Tank.
• Be careful to avoid contaminating the surrounding area with ink.
• Be careful to avoid bending the ink tubes.
6. Detach the Buffer Tank and the tank shade sheet.
Tank shade sheet
Buffer Tank
7. Follow the procedure in the reverse order for assembly.
• Be sure to connect the ink tube correctly.
• We recommend replacing the tube removed from the Buffer Tank. If no tube is at hand,
cut approximately 5 mm off the end of the tube before reinserting.
8. Turn on the main power supply and press the [END/POWER] key.
2
To Next Page
Loading...
