MIMAKI TS100-1600 - 3.2.2 Head Adjustment; Slant Adjust

Chapter 3 Adjustment > Adjust Menu>Head Adjustment
130
>
R
e
v
3.2.2 Head Adjustment
l Overview
Check the printed built-in pattern with a magnifying glass. Adjust the head slant and stagger.
• Insufficient head adjustment will affect other adjustments.
• Set the head height to the "LOW" position before checking and adjusting.
• Perform Slant Adjust and then Stagger adjustment.
• When adjusting either Slant Adjust or Stagger adjustment, be sure to check the other. Repeat
the adjustment until no further adjustment is required.
Slant Adjust
Check to confirm that the slant of each head is within the specified value. Adjust it if not within the specified
range.
Head 1Head 1
Head 2Head 2
Support
Support
Adjustment cam
Adjustment cam
Loosen
Loosen
Loosen
Loosen
Loosen
Loosen
ABC D
ABC D
ABC D
㼩
㼩
Head 1
Head 2
Partition line
No goodOK
Slanting to left Slanting to right
Correct image
10 μm or
greater
10 μm or
greater
[Built-in pattern]
l Procedure
1. Remove the following covers.(1.5)
(1) Front cover front
(2) Front cover upper
(3) Carriage cover
(4) Top cover
2. Position the media.