MIMAKI TS100-1600 - Page 129

Chapter 3 Adjustment > Adjust Menu>Drop.PosCorrect
129
l Reference setting flow
Perform dot position correction
* Make [SiDir] and [ReDir] adjustments for "720Hi"
Execute [Reference Setting]
Perform dot position correction
* Make [BiDir] adjustments for "720Hi"
Perform dot position correction
* Make [SiDir], [ReDir], and [BiDir] adjustments for other than "720Hi"
l Procedure
1. Perform "720Hi" drop position correction.
• Adjustment sequence:
[BiDir] [ReDir]
2. Select [#Adjust] > [Drop.PosCorrect], then press the [ENTER] key.
3. Select [Reference setting], then press the [ENTER] key.
4. Press the [ENTER] key to start reference setting.
• Reference setting cannot be performed unless you have performed "720Hi" drop position
correction.
3