MIMAKI TS100-1600 - Machine Setup Menu

Chapter 2 Replacement of Maintenance Parts > Ink Supply Related>Damper
81
12. Follow the procedure in the reverse order for assembly.
(1) Push in the Damper until it engages with the claws.
• Be careful to avoid catching the Head cable.
(2) Push in the double damper FIT until it engages with the claws.
• Improper attachment may result in leaking ink.
• If the double damper FIT has been removed, apply maintenance liquid to the seal rubber.
If maintenance liquid is not applied, friction between the damper and the seal rubber may
cause the seal rubber to become deformed, resulting in ink leakage.
Deformation
• Use the correct maintenance liquid for the ink in use.
13. Insert the sponge previously removed between the dampers.
• Push the sponge into the position shown in the diagram.
Push in as far as here
14. Turn on the main power supply and press the [END/POWER] key.
15. Dispose of the ink in the waste ink tank and reset the waste ink tank counter.
16. Perform the following:
(1) [#Adjust] > [Fill Up Ink]
(2) Test print.
• Check to confirm the nozzle is not clogged.
2