Chapter 3 Adjustment > Adjust Menu
125
Item Purpose Overview Ref.
Wiper
Adjustment
• If cleaning is unsuccessful • Adjust the wiper position in the X and Y
directions.
P. 136
Discharge and
Washing
• To discharge ink or
maintenance liquid inside the
ink route
• If cleaning is unsuccessful
• --- P. 138
Serial No. • To check the serial number • Cannot be changed (To change the
value, the parameter must be reset.)
-
Dealer No. • To confirm/alter dealer
number
• --- -
Feed Comp 2 • If streaks appear on the print
• If the parameters have been
reset
• Adjust the media feed amount.
P. 139
Angle Adjust • Not currently implemented
(used for manufacturing)
• --- -
LAN Config • Not currently implemented
(used for development)
• --- -
Edge Adjust • If the system parameters
have been reset
• If the print positions are offset
at both ends of the media
• Adjust so that the left- and right-hand
margin widths on the media match the
specified value (15 mm).
P. 140
Pointer Offset • To adjust the LED pointer
position
• Adjust the origin of the LED pointer. P. 141
Time Set • To adjust the time • --- -
Fill Up Ink • If the "Print head"(P. 75) was
replaced
• No nozzle clogging in the test print -
NCU • If the NCU was replaced
• If an NCU absorber
replacement error occurs
• Adjust the NCU (nozzle clogging
detection unit) slant and ink ejection
positions and reset the NCUpad count.
P. 142
Initial
maintenance
liquid Filling
• To fill with maintenance
liquid.
• Fill with maintenance liquid. P. 171
Replace Head • If the "Print head"(P. 75) is
replaced
• If the "Damper"(P. 79) is
replaced
• Ink discharge from Head: Drain the ink
from inside the head and damper.
P. 144
IC registration
information
• Temporary registration: In
unavoidable circumstances
such as when the main PCB
is replaced and no
parameters are backed up or
when no ink IC chip is
available for registration.
* Normally, the IC information
is restored when the
parameters are initialized and
then downloaded.
• Reset: To change the ink set.
• Temporary registration: The ink IC can
be registered without using an IC chip.
– The ink level becomes 100%.
– The expiration date is six months after
the working date.
– The maximum allowable number of
temporary registrations is three times
per slot for one main PCB (including
the number of downloading the main
PCB parameters for restoration).
-
3
To Next Page
Loading...
