Chapter 3 Adjustment > Adjust Menu>Head Adjustment
133
6. Perform the following if adjustment is required.
(1) Press the key to move the head over the platen.
(2) Loosen the retaining screws of the Head to be adjusted.
(3) Rotate the adjustment lever to adjust.
• Clockwise: Head moves to the rear side.
• Counterclockwise: Head moves to the front side.
(4) Check the built-in pattern once again.
• Repeat the adjustment until no further adjustment is required.
(5) After adjusting, tighten the retaining screws of the Head.
(6) Check the Slant Adjust again.
3
To Next Page
Loading...
