Chapter 5 System Overview > Initial maintenance liquid Filling
172
5. Attach the accessory syringe.
6. Press the key to open the valve.
7. Aspirate the maintenance liquid with a syringe.
8. When the maintenance liquid reaches the end of the fitting, press the key to close the valve.
9. Press the [ENTER] key.
10. Remove the syringe.
11. Connect the maintenance liquid route fitting.
12. Press the [ENTER] key to start filling the maintenance liquid.
13. Once complete, check to confirm the maintenance liquid is filled.
[ENTER]: Start additional filling
[END]: Confirm (end)
• Additional filling is also possible with the following procedure:
(1) Perform [#ADJUST] > [Maintenance liquid] > [FILL UP].
To Next Page
Loading...
