Chapter 2 Replacement of Maintenance Parts > PCB/Power Supply Related>Main PCB
34
11. Turn on the main power supply, then hold down the keys to start up and initialize.
• Set the System parameter "INITIAL" to 1 (initialization).
• Press [END/POWER] > [ENTER] to initialize. Turn off the main power supply once initialization is
complete.
• Be sure to initialize the parameters. Failure to do so may prevent rewriting the ink IC
information.
12. Turn on the main power supply, then turn on the sub power supply while pressing the key.
13. Download the parameters uploaded at the beginning.
• Downloading the parameters restores the ink registration information on the ink IC chip for
all slots.
• The ink registration information on the ink IC chip can be restored up to three times per
main PCB (including the number of temporary registrations by selecting [#ADJUST] > [IC
registration information] > [Temporary registration]).
14. Reattach the covers.
l Connector list
No. Pin Intended use AC/DC Remarks
CN1 4 USB DC
CN2 16 Power supply control, UART, SD memory control DC
CN3 80 Spare DC
CN4 9 Spare DC
CN5 80 For expansion memory PCB DC
CN7 20 Y origin sensor, cover switches, etc. DC
CN9 20 IO PCB IF DC
CN11 6 Power supply input DC
CN12 6 Power supply control DC
CN13 12 Ethernet DC
CN14 4 Motor power DC
CN15 10 Motor encoder DC
CN16 5 Spare DC
CN100 18 Color LCD IF DC
CN102 3 For regenerative resistance PCB connection DC
CN104 14 Slider IF connection DC
CN105 20 Spare DC
CN106 18 Slider IF connection DC
CN110 6 Spare DC
CN111 5 Spare DC
CN112 4 Spare DC
*1. For details of the ports to connect to, check the block diagram.
To Next Page
Loading...
