Chapter 2 Replacement of Maintenance Parts > Drive Related>Y Driven Pulley
71
9. Follow the procedure in the reverse order for assembly.
• Attach so that the E-rings are on the outside of the Y-T pulley BKT.
• Adjust the two Y-SP plate screws so that the gap shown in the diagram below is between 3 mm
and 5 mm.
• Do the following to attach the belt:
(1) Attach the belt so that it is level between the pulleys.
OK
No good
No good
OK
Level between pulleys
Belt toward top but level
Belt toward bottom
Belt at an angle
2
To Next Page
Loading...
