Chapter 2 Replacement of Maintenance Parts > Ink Supply Related>Maintenance liquid cartridge valve
86
7. Remove the snap pin A, then remove the ink cartridge solenoid.
8. Follow the procedure in the reverse order for assembly.
• If the fitting is removed from the tube, cut approximately 5 mm off the end of the tube before
reinserting.
Fitting with the seal rubber attached
• Apply maintenance liquid to the seal rubber. If maintenance liquid is not applied, friction
between the fitting and the seal rubber may cause the seal rubber to become deformed,
resulting in ink leakage.
• Use the correct maintenance liquid for the ink in use.
9. Check the fitting mounting.
• Improper attachment may result in leaking ink.
To Next Page
Loading...
