Chapter 2 Replacement of Maintenance Parts > Ink Supply Related>Filter
94
• Make sure the filter is installed in the correct direction.
Fitting with the seal rubber attached
• Apply maintenance liquid to the seal rubber. If maintenance liquid is not applied, friction
between the fitting and the seal rubber may cause the seal rubber to become deformed,
resulting in ink leakage.
• Use the correct maintenance liquid for the ink in use.
8. Check the fitting mounting.
• Improper attachment may result in leaking ink.
9. Turn on the main power supply and press the [END/POWER] key.
10. Dispose of the ink in the waste ink tank and reset the waste ink tank counter.
11. Perform the following:
(1) [#Adjust] > [Fill Up Ink]
(2) Test print.
• Check to confirm the nozzle is not clogged.
To Next Page
Loading...
