EasyManua.ls Logo

Mindray A5 - Page 190

Mindray A5
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Alarm and Prompt Messages Alarms and Messages
6 - 28 046-003777-00 A5/A3™ Operating Instructions
Fresh gas flow detected!
Adjust all flowmeters to
zero
After fresh gas flow is
turned off or after exiting
"Manual Circuit Leak
Test" or "Automatic
Circuit Leak Test &
Compliance Test" screen.
This message appears in the first "Manual
Circuit Leak Test" or "Automatic Circuit
Leak Test & Compliance Test" screen when
fresh gas flow is detected.
Access to System settings
only available in Standby
5 sec This message appears when the current
mode is in non-standby and the user tries
to enter the Setup > System menu.
Can not end case while
fresh gas flow is detected!
5 sec This message appears when user tries to
end the case by pressing the disabled End
Case button while fresh gas is on, Auto/
Manual switch is set to Manual, and the
system is in non-standby.
Set Auto/Manual switch to
Manual position before
starting case
1. When triggered by
turning on fresh gas, it
will disappear after fresh
gas flow is turned off or
Auto/Manual switch is
set to Manual;
2. When triggered by
touching the Waveforms/
Spirometry screen, it will
disappear after 5 seconds
or Auto/Manual switch
is set Manual.
When Auto/Manual switch is in Auto
position and system is in Standby mode,
this message will appear in the following
cases:
1. Turning on fresh gas
2. Touching the Waveforms/Spirometry
screen
Set Auto/Manual switch to
Manual position and adjust
all flowmeters to zero.
5 sec This message appears in the first
"Automatic Circuit Leak Test & Compliance
Test" screen when pressing the disabled
Continue button.
Set Auto/Manual switch to
Auto position and adjust
all flowmeters to zero.
5 sec This message appears in the first "Manual
Circuit Leak Test" screen when pressing the
disabled Continue button.
Can only End Case in
Manual Mode!
5 sec This message displays when the Auto/
Manual switch is in Auto position and the
system is in non-Standby, then if the user
presses the disabled End Case button.
MESSAGE TIMEOUT REMARK
TABLE 6-11 Prompt Messages Displayed in Pop-up Area

Table of Contents

Other manuals for Mindray A5

Related product manuals