93
Kaleido-X
User’s Manual
3Drag Multicast from the Tools pane onto the network adapter.
The Multicast Stream Configuration window appears.
4In Multicast Stream Configuration, replace the default stream name if desired, select
the appropriate protocol (RTP, UDP), type the multicast group address and port
number associated with the transport stream you wish to add.
5 Select the Source specific multicast (SSM) check box, type the IP address associated
with the specific source you wish to monitor in the Source IP address box, and then
click OK.
The Kaleido-IP establishes a connection with the selected SSM/SFM stream. All
programs that are part of the selected stream, and the elementary streams included in
these programs, automatically appear under the transport stream element in the
System list.
Notes
• The Kaleido-X software supports UTF-8 encoded stream names. The only
characters, which cannot be used in a stream name are:
@ / \ ' and ".
• Verify the protocol you selected. Registering an RTP stream as UDP instead
of RTP may result in the decoded video appearing jerky or accelerated on
the monitor wall.
Note: In the case of streams that are available from the same multicast
group address and port number, you must enter the source IP address
associated with a stream before you can add the next one.
To Next Page
Loading...
