Miranda Kaleido-X - To Toggle the Cropping Mode Using the RCP-200; To Toggle the Cropping Mode Using the Mouse

38
Operation of the Monitor Wall
Video Cropping/Zooming
To toggle the cropping mode using the RCP-200
1 Touch the WALL MOUSE category if it is not already selected, and then move the
pointer over the video source whose cropping mode you wish to change on the
monitor wall.
2 If you have yet to assign the UNDERSCAN wall function to one of the programmable
knobs, rotate the knob you wish to program until UNDERSCAN is selected, and then
press the knob.
UNDERSCAN appears above the programmed knob.
3 Press the UNDERSCAN knob.
The video source’s cropping mode changes. Continue pressing UNDERSCAN to
alternate between underscan and overscan mode.
To toggle the cropping mode using the mouse
• Right-click the video source.
If the video is in underscan mode, then the shortcut menu will allow you to change to
overscan.
If the video is in overscan mode, then the shortcut menu will allow you to change to
underscan.
Notes
• The Kaleido-IP does not yet support cropping.
• The overscan margins are set to 5% by default. They can be customized in
XEdit (see
Cropping Mode, on page 197).
Overscan
Underscan