37
Kaleido-X
User’s Manual
Changing a Source’s Aspect Ratio
To change the aspect ratio using the Kaleido-RCP2
• Move the pointer over the video source whose aspect ratio you wish to change, and
then press ASPECT RATIO on the Kaleido-RCP2. Continue pressing ASPECT RATIO to
alternate between the available aspect ratio options (4:3, 16:9, and possibly a third
custom aspect ratio if one was defined in XEdit for the monitor).
To change the aspect ratio using the RCP-200
1 Touch the WALL MOUSE category if it is not already selected, and then move the
pointer over the video source whose aspect ratio you wish to change on the monitor
wall.
2 If you have yet to assign the ASPECT RATIO wall function to one of the programmable
knobs, rotate the knob you wish to program until ASPECT RATIO is selected, and then
press the knob.
ASPECT RATIO appears above the programmed knob.
3 Press the ASPECT RATIO knob.
The video source’s aspect ratio changes. Continue pressing ASPECT RATIO to alternate
between the available aspect ratio options (4:3, 16:9, and possibly a third custom
aspect ratio if one was defined in XEdit for the monitor).
To change the aspect ratio using the mouse
1 Right-click the video source.
2 On the shortcut menu, point to Aspect Ratio, and then click 4:3 or 16:9.
The video is resized accordingly within the layout.
Video Cropping/Zooming
To toggle the cropping mode using the Kaleido-RCP2
• To change the current cropping mode, move the mouse pointer over the video source
whose cropping mode you wish to change, and then press the UNDERSCAN button on
the Kaleido-RCP2. Continue pressing UNDERSCAN to alternate between underscan and
overscan mode.
Note: There may be one more choice on the menu if you set a custom
aspect ratio in XEdit, for this monitor.
See Setting a Video Monitor’s Aspect
Ratio on page 214.
To Next Page
Loading...
