340
Tally Interface Devices
Ross Video Production Switcher
Depending on the multiviewer model, the available RS-422 ports are designated as
follows:
8 Click the peripheral device icon in the Interconnects tab.
9In the Properties pane, set the serial communications properties for the device.
Serial communications properties (example showing the default properties for a Kalypso device)
The set of properties will vary, depending on the device. Refer to the manufacturer’s
documentation for your specific device as needed.
10 On the File menu, click Save.
Ross Video Production Switcher
A multiviewer can receive dynamic source names and tally information from a Ross Video
production switcher (Synergy 2, 3, 4 SD/MD and Vision models). The procedures below
describe how to set up the multiviewer to interface with a Ross Video switcher.
KMV-3901/3911 RS-422
Kaleido-X16 Port 1, and Port 2
Kaleido-X (14RU) Frame A – Output A, B, and C; Frame B – Output A, B, and C
Kaleido-X (7RU) Output A, B, C, and D
Kaleido-X (4RU) Output A, and B
To Next Page
Loading...
