73
Kaleido-X
User’s Manual
2 If your PC and the multiviewer are on the same subnet, then you can select the IP
address of the multiviewer from the list. Otherwise type the appropriate IP address in
the box.
3Click OK.
A window appears, prompting you to confirm that you really want to export data to the
multiviewer.
4Click Ye s.
5 If access control is enabled for this multiviewer, then XEdit prompts you for a password.
Type the password associated with the RCP user “Admin”, and then click Log on.
A progress window appears, followed by a message stating whether the export
succeeded or not.
6Click OK.
All data on the remote system is now replaced with content from the local workspace.
Exporting a Cluster Database
To export a cluster database
1On the Configure menu, point to Database, and then click Export.
The Export Cluster window appears, prompting you to confirm the set of multiviewers
to which you wish to apply the database.
To Next Page
Loading...
