74
Managing Kaleido-X Systems
Exporting a Database
If you were working in offline mode, against a database imported from your existing
cluster system, and all cluster members are currently available, then click OK to
proceed.
On the other hand, if a cluster member happens to be unavailable, or if you are cloning
a cluster configuration to a different set of multiviewers, you may need to remove
members from the selection and change IP addresses.
a To change an IP address, double-click an IP address, and then type the IP address of
the actual multiviewer that is to receive this database.
b To remove a cluster member that is currently not available from the selection, clear
the corresponding check box.
Similarly, you may remove members if your target cluster does not have as many, or
if you wish to update members that were previously unavailable with the same
database you already exported to other cluster members.
c Once the selected IP addresses match the actual multiviewers that are to receive
the database, click OK.
In the case of a partial export, a warning appears prompting you to confirm you
intention; click OK to proceed.
A window appears, prompting you to confirm that you really want to export the
database.
2Click Ye s.
3 If access control is enabled for a multiviewer, then XEdit prompts you for a password.
Type the password associated with the RCP user “Admin”, and then click Log on.
IMPORTANT
Partial exports should be limited to cases where you had to replace a
defective cluster member and need to bring its replacement into service
without disrupting operations.
Before performing a partial export, you must verify that the cluster
configuration has remained unchanged between your local version and the
online version currently on the system.
To Next Page
Loading...
