402
Administration and Servicing
Assigning an IP Address to Each Device in Your System
Changing an IP Address on Windows 7
To change the IP address of a client PC that has Windows 7
1Click the Start button, and then click Control Panel. In the search box, type “adapter”,
and then, under Network and Sharing Center, click View network connections.
2In Network Connections, right-click Local Area Connection, and then click Properties.
If the system prompts you for an administrator password or confirmation, type the
password or provide confirmation.
The Local Area Connection Properties window opens.
3On the Networking tab, under This connection uses the following items, click
Internet Protocol Version 4 (TCP/IPv4), and then click Properties.
The Internet Protocol Version 4 (TCP/IPv4) Properties window opens.
4On the General tab, click Use the following IP address.
5 Type an IP address in the same range as the default IP address of the multiviewer. For
example, if the IP address of the multiviewer is “10.0.3.70”, then the IP address of your
client PC could be “10.0.3.123”. If you are unsure, contact your network administrator.
6 Type a subnet mask in the same range as that of the multiviewer.
7Click OK.
8In Local Area Connection Properties, click OK.
Configuring the RCP-200
The RCP-200 is shipped with an IP address of 10.0.3.200. On installation, you should consult
your system administrator and replace this address with an appropriate address for your
local network configuration (see
Configuring the RCP-200’s IP Settings, below). Once your
RCP-200 has an active connection to the network, you must then register the multiviewers
you wish to operate from the RCP-200 (see
Specifying Multiviewers for the RCP-200, on
page 403), and their respective KX Router logical routers (see Specifying Lookup Servers for
the RCP-200, on page 403). Once this is completed, you will be able to control the monitor
wall from the RCP-200 (see Logging on to the RCP-200, on page 403).
Configuring the RCP-200’s IP Settings
To assign an IP address to the RCP-200
1 Press the CONFIG button, located between the two screens on the front of the RCP-200.
2 Touch the COMM category at the top of the right-hand screen.
3 Touch the ETHERNET tab on the right-hand screen.
4 In the SELECT area, rotate the leftmost control knob to select IP ADDRESS.
5 Use the four control knobs in the CHANGE area to set the new address.
The current address is displayed in the CURRENT box for reference, and the new
address you are setting appears in the MODIFIED box, as well as at the controls.
6 Press the SAVE control knob to store the new address.
7Repeat from step 4 to configure the NETWORK MASK and GATEWAY settings.
8 Press the RESTART control knob to apply the changes.
The panel will go dark for about 15 seconds before the startup screens appear.
To Next Page
Loading...
