360
Tally Interface Devices
Kayenne Production Switcher
Configuring Layout Elements
To configure layout elements
1In the Layouts tab, create layouts and assign the logical sources you configured (see
“Assigning Kayak Tallies, Input Names, and Output Names to Logical Sources” above) to
monitors that can display text (e.g. UMD) or alarms (e.g. UMD, video, text alarm status).
2 Depending on your purposes, assign the appropriate text or alarm levels to specific
components within the monitors (e.g. assign an alarm level to a tally component in an
UMD, or a text level to the UMD text component).
3On the File menu, click Save.
4On the Configure menu, point to Database, and then click Export to export the
database to your multiviewer.
On the monitor wall, you can now load the layout containing the monitors that were
assigned dynamic text and tallies provided by the Kayak switcher. Input and output names,
as well as tally status from the Kayak switcher will be visible on the wall. Any changes made
by the switcher’s operator will be immediately reflected.
Kayenne Production Switcher
A multiviewer can receive dynamic source names and tally information from a Grass Valley
Kayenne Video Production Center. The procedures below describe how to set up a
multiviewer to interface with this family of production switchers.
0xDA ME2 UtilA ME2 UtilA M2p2
0xDB ME2 UtilB ME2 UtilB M3p2
0xDC ME2 UtilC ME2 UtilC Mhp2
0xDD ME3 UtilA ME3 UtilA
0xDE ME3 UtilB ME3 UtilB
0xDF ME3 UtilC ME3 UtilC
0xE0..0xEF Virtual Input
00...15
Virtual Input
00...15
Virtual Input
00...15
Virtual Input
00...15
Virtual Input
00...15
0xF0 WHITE WHITE WHITE WHITE WHITE
Input
Number
DD35 XtenDD HD XtenDD SD KayakDD Kayak SD/HD
To Next Page
Loading...
